国产成人午夜精品5599,欧美丰满美乳XXⅩ高潮www,欧洲无人区卡一卡二卡,国产白丝无码视频在线观看

I. Overview

For non-bevel cutting machines, the laser direction is perpendicular to the stretching direction of the tube. Due to this limitation, when cutting the tube at an angle, the final cut surface differs from that in the drawing, as shown in the figure below:

The protrusion on the wall thickness makes it impossible to successfully assemble the parts during subsequent welding. To solve this problem, it is necessary to adjust the toolpath based on the original drawing, and this adjustment method is called Weld Seam Compensation.

Note: Italic texts with blue highlights are? clickable tutorial links that lead to detailed parameter explanations and usage instructions.

?

II. Scope of Application

1. Application

Closed tubes with inner contours and no sharp corners in the cross-section (i.e., R = 0); if there are sharp corners, they need to be rounded in advance.
Angle steel, channel steel in special toolpaths, and non-chamfered rectangular tubes that have used the 【Quick Rectangle Toolpath】?function.

2. Scenarios

?

• • • Case 1: T-joint/tilt cutting of circular tubes

?

• • • Case 2: Bevel cutting of angle steel, channel steel, and rectangular tubes

For details, please refer to 《TubesT - Toolpath Tutorial for Non-Beveling Machines: Rectangular Tubes, Angle, Channel steel》.

III. Usage

1. Adding separately to parts and toolpaths

After selecting the part and toolpath, click Weld Seam Compensation in the Technique Setup to add it.

?

2. Manual Batch Addition

①In the part list, select the parts that need weld compensation, right-click on the parts and click Add Weld Seam Compensation to add in batches.

②In the Weld Seam Compensation drop-down menu, select Offset?All Sections.

3. Automatic Batch Addition

When you need to add Weld Seam Compensation to all imported parts in batches, check the weld compensation in 【Auto Technique】?and set the corresponding parameters.

**Notice: Enable Auto Technique first, then import the parts. If you import the parts first and then enable Auto Technique, the previously imported parts will not have weld compensation added.

Disable this when not required in case of causing errors in toolpath after importing parts

?

?

IV. FAQs

1. Can the compensation value be modified?

2. Will Weld Seam Compensation affect the length of the part?

3. How to handle the R-angle interference problem for rectangular tubes with large chamfers and thick walls?

?

4. What may be the reasons for the failure or ineffectiveness of weld seam compensation settings?

?

?

?

?